A proper local plumber for everything from a dripping tap to a mains stopcock, a leaking cistern to a blocked waste, with over 30 years of South East London homes behind him and a fair, transparent price on every job.
£80 minimum labour · Rapid emergency response
A good local plumber isn't cheap, but a good local plumber saves you the cost of a bad one three times over.
Plumbing failures follow a predictable pattern: small, ignored, catastrophic.
An underfloor leak from a compression joint saturates joists over months. Ceilings drop. Floors need replacing. £8,000+ of damage from a £45 joint.
A leaking flush valve wastes 400 litres a day. Metered households pay for every drop.
SE London freezes hard enough every few winters to burst any pipe in a loft or external run that isn't lagged. Repair after the fact runs to thousands.
A stopcock that's seized when you need it costs you an hour of flooding while you find and remove the outside toby.
Common mistakes we fix
Describe the problem, we'll usually know what to bring on the van before we arrive.
Isolate the affected supply, pressure-test where needed, identify the fault properly, quote before starting.
Fixed cleanly, copper, plastic push-fit or compression as appropriate, tested under pressure before we close up.
Off-cuts removed, floor sheeted, silicone re-run where needed, you shouldn't be able to tell we were there.
Every job written up on the invoice with parts and labour itemised.
Bursts, floods and full-water-off across SE London prioritised for a rapid response.
We know the quirks: Victorian lead-jointed mains, 1930s copper, 1970s Cortina plastic, everything since.
£80 minimum labour, transparent per-hour thereafter, no cash-only surprises.
Dripping tap? Loose toilet seat? Not too small, we'll price it fairly.
Compression, capillary or push-fit, chosen for the job, not chosen for speed.
Every repair written up on the invoice with parts and labour itemised.
Almost every plumbing job in a domestic home is one of a familiar list. Here's what we handle.
Underfloor, in-wall, boxed-in and exposed pipework, copper, plastic and (in older SE London stock) lead. Sound-mapped where hidden, isolated, and repaired using the correct fitting for the pipework type. Never bodged with resin tape as a permanent fix.
Full range of monobloc, twin-lever, wall-mounted and outdoor bib taps, supplied and fitted, or fit-only. Ceramic cartridge upgrades on tired mixers save hundreds vs full replacement.
Full pan-and-cistern replacements, dual-flush conversions, flush valve repairs, ball-valve replacements and soft-close seat upgrades. Concealed cisterns supported end-to-end.
Blocked sinks, showers, baths and WCs cleared using hand augers, rods or drain snakes, no chemical solutions that damage pipework. Slow drains rectified with correct fall correction where the underlying issue is layout.
Failed or seized stopcocks replaced, PRV fitted where mains pressure exceeds 5 bar and puts fittings at risk, whole-house water softeners installed in hard-water areas.
Mains bursts, ceiling floods, tenant emergencies, freeze splits, prioritised across SE London and North West Kent, evening and weekend cover for existing customers as standard.
£80 minimum labour, covering the first hour on-site and any repairs achievable within that. Additional time is quoted per hour, transparent and agreed before we start.
Yes, bursts, floods and no-water emergencies prioritised across SE London. Evening and weekend cover available for existing customers as standard.
Response times vary with workload. We prioritise genuine emergencies and give you an honest ETA when you call, whether that's under an hour or a couple of hours. Non-urgent bookings usually within 2–5 working days.
Yes, happily. Just check compatibility with your existing plumbing before you buy, or ask us for a spec.
We work with existing lead pipework where necessary, but always recommend upgrading to copper or plastic, lead is a health risk to modern water supply standards.
Yes, we sound-map and pressure-test to locate hidden leaks, and where truly buried we can arrange thermal imaging to trace.
Yes, full-house softener installation with correct isolation, drain routing and salt tank access. Bexley and Dartford water is measurably hard and softeners often pay back inside 3 years.
An itemised invoice covering parts and labour on every repair, plus manufacturer warranties on any new parts fitted.
Speak to Danny directly. Free quote in writing, honest advice, and a fair fixed price. No sales pressure, we’ve been at this for over 30 years for a reason.